Coupled Cones
Jacked Flat Bottom Cake Cones
Marron Glacés
Communion Hosts / Sacramental Bread
Chocolate Waffle Cone with Sprinkles
Sugar Wafer Stick
Pasteurizer for Ice Cream
Cups for Ice Cream
Shoulder Pads
Wadding For Shoulder Pads
Sleeve Head Rolls
Waistband
Filters
Panel Filters
Bag Filters
Flexible Control Cable
The equipment bends the brass tube for a settable quantity.
This is composed of an iron workbench on which the following units are applied:
– a template with various registers for adjusting the amount of curvature
– a lever with manual locking in position
ECT – Tube Bending Equipment
Technical Data
The equipment takes about 2 sec. to carry out the work cycle.
– dimensions: cm. 90 x 40 x H20
– weight: 20 Kg
– pneumatic supply 5 bar
The operator inserts the part in the template seat, manually positions the support on the collar and inserts the pin in the large hole of the part.
At this point he presses the two buttons to start the work cycle; at the end of this he manually removes the machined piece and the pin inserted in it.
Notes: The data included are not binding
